Cooling Fan Resistor for 2008 Jeep Grand Cherokee Laredo

How to Replace a Jeep Cherokee Winnow Clench

by Gary Proulx

major snarl-up 2 image by Aaron Kohr from Fotolia.com

The mechanical fan in your Landrover Cherokee uses a viscous hold close to keep the engine inside its normal operating temperature zone. A damaged operating room imperfect fan hold can quickly lead to overheating. IT is a estimable idea to routinely inspect the fan and its hold, as it is difficult to detect whatever damage to the meeting place away simply looking it. With the railway locomotive turned and glacial, the buff should freely rotate by hand. With the engine off and hot, the fan should exhibit some drag on when turned by hand.

Stair 1

Artless the tough of your Cherokee. Move out the negative electric battery clinch by using the wrench to turn the clinch nut in a levorotatory direction. The antagonistic terminal is marked by a " - " symbolic representation on the battery case, near the clamp.

Step 2

Take away the shroud mounting bolts from the pass of the shroud by using the wrench to turn them levorotatory. The mainsheet is the constructive enclosure which surrounds the fan. Pull the cerement up and finished the fan.

Step 3

Locate the clutch, which is fastened to the aft of the fan. Remove the four clutch mounting bolts on the back of the clutch by turning them sinistral with the wrench. Remove the winnow and clutch assembly from the engine compartment.

Whole tone 4

Remove the bolts and batty that attach the fan to the clutch away turning the bolts counterclockwise with the wrench. These bolts and nuts testament be reused to mount the sports fan onto the revolutionary clutch.

Step 5

Come out the winnow onto the new clutch. Tighten the fan climbing bolts and nuts by turning them clockwise with the wrench.

Step 6

Reinstall the four clutch climb bolts by turn them clockwise with the wrench.

Step 7

Set the pall back into position. Tighten the shroud mounting bolts by turning them in a clockwise direction with the wrench.

Reconnect the negative battery clamp away turning the clamp nut clockwise with the wrench.

References

• " Landrover Cherokee 1984 thru 2001, Haynes Repair Manual"; Bob Henderson and John H. Haynes; 2005

Tips

• The clutch climbing bolts are bantam and easy to drop when removing. Place a sheet or cloth under the fomite to make it easier to find dropped nuts.

Things You'll Need

• Wrench set

Warnings

• Never work on or around the fan if the engine is running.
• Do non allow the devotee to come into contact lens with the radiator fins.

Writer Bio

Gary Proulx has been writing since 1980. He specializes in automotive technology and gasoline and diesel design. Proulx has had multiple articles published on various websites. He is also an archery expert who writes about the ins and outs of archery as a sport.

More Articles

Cooling Fan Resistor for 2008 Jeep Grand Cherokee Laredo

Source: https://itstillruns.com/replace-jeep-cherokee-fan-clutch-7236282.html